LATICRETE® 9235-Waterproofing Membrane-Data Sheet

Data Sheets are subject to change without notice. LDS236aus.0 230507
1
1. PRODUCT NAME
LATICRETE® 9235 Waterproofing Membrane
2. MANUFACTURER
LATICRETE Pty Ltd.
464 Geelong Road,
Footscray West. VIC. 3012.
Telephone: 03 99336111
Toll Free: 1800331012
FAX: 03 99336199
Email: This e-mail address is being protected from spambots. You need JavaScript enabled to view it
Internet: www.laticrete.com
3. PRODUCT DESCRIPTION
LATICRETE 9235 Waterproofing Membrane is a thin,
load-bearing waterproofing designed specifically for, but
not limited to, the special requirements of ceramic tile,
stone and brick installations. A self-curing liquid rubber
polymer and a reinforcing fabric are quickly applied to
form a flexible, seamless waterproof membrane that
bonds to a wide variety of substrates.
Uses
- Swimming Pools, Fountains & Water Features
- Shower Pans, Stalls, “Hop-ups” & Tub Surrounds
- Bathrooms & Laundries (Industrial, Commercial &
Residential)
- Spas, Hot Tubs
- Kitchens & Food Processing Areas
- Terraces & Balconies
- Counter Tops
- Facades
- Steam Rooms (when used in conjunction with a
vapor barrier)
Advantages
- Safe - no solvents and non-flammable. Low VOC’s.
- Interior & exterior use
- Vertical & horizontal surfaces (including ceilings)
- Thin - only 0.5mm thick when cured
- Load bearing - “Extra Heavy” Service Rating per
ASTM C627/TCA
- Cold applied –no heating, kettles or fumes
- Applies quickly with a paint brush or roller - no
special mixing or application equipment needed
- Fast cure - normally ready in hours for finishes
- Install tile, brick and stone directly onto membrane
- Resistant to brine, urine, sugar & other reagents
- Easy cleanup –just use water while fresh
- Protects concrete & reinforcing steel from corrosion
Suitable Substrates
-Concrete -Exterior Grade Plywood*
-Cement Mortar Beds -Gypsum Wallboard*
-Cement Backer Board***
-Cement Plaster
-Ceramic Tile and
Stone**
-Concrete & Brick
Masonry
-Cement Terrazzo**
*Interior Applications Only;
** If skim coated with a LATICRETE Latex Thin-Set Mortar;
***Consult cement backer board manufacturer for specific
installation recommendations and to verify acceptability for
exterior use.
Packaging
Full Unit (36 Full Units/pallet) consisting of:
1 x 23 litre pail liquid
1 x 25 m2 roll fabric 1 m wide.
1 x 25 m long, 150 mm wide.
Mini Unit :
1 x 7.6 litre jug liquid;
1 x 150mm x 23m roll fabric
Color
Black
Approximate Coverage
___Full Unit__ __Mini Unit__
27.8 m2 9.3 m2
Shelf Life
Factory sealed containers of this product are
guaranteed to be of first quality for two (2) years if
stored at temperatures -0-C and -43-C.
Limitations
- Do not use over expansion joints, structural cracks
or cracks with vertical differential movement
- Do not use over cracks >3mm in width
- Do not use as a vapor barrier (especially in steam
rooms)
- Do not expose unprotected membrane to sun or
weather for >30 days
- Do not expose to negative hydrostatic pressure,
excessive vapor transmission, rubber solvents or
ketones
- Must be covered with ceramic tile, stone, brick,
concrete, screeds, terrazzo or other traffic-bearing
course. For temporary cover, use protection board.
- Do not install directly over single layer wood floors,
plywood tubs/

LATICRETE® 9235- Data Sheet