LATICRETE® Watertight-Floor N’ Wall Waterproofing 9240-Data Sheet

1. PRODUCT NAME
LATICRETE® Watertight Floor N’ Wall Waterproofing
9240 with Bio Barrier
2. MANUFACTURER
LATICRETE Pty Ltd.
464 Geelong Rd,
Footscray West. VIC. 3012.
Telephone: 03 99336111
Toll Free: 1800331012
Fax: 03 99336199
Email: This e-mail address is being protected from spambots. You need JavaScript enabled to view it
Internet: www.laticrete.com.au
3. PRODUCT DESCRIPTION
LATICRETE Watertight Waterproofing Membrane
with Bio Barrier is an easy to use liquid rubber
waterproofing designed for use under thin & thick
bed installations of ceramic tile and stone in wet
areas such as balconies, bathrooms and kitchens.
Protects substrates behind the tiles from water
damage and inhibits stain causing mold and mildew
growth with Bio Barrier anti-microbial protection. For
internal and external application.
Complies with; AS/NZS4858-2004.
Advantages
- Inhibits stain causing
mold and mildew growth
with Bio Barrier antimicrobial
agent
- Protects substrates from
water damage
- Suitable for immersion in
showers of residential wet
areas.
- High bond strengths with
good adhesives
- Easy to install –applies
like paint
- Water cleanable
- Low odour - Low V.O.C.’s
Suitable Substrates
- Concrete- Cement Mortar Beds
- Cement Backer Board^ - Cement Plaster
- Gypsum Wallboard* - Concrete Masonry
- Cement Screeds - Brick Masonry
- Exterior Grade Plywood and Particle Board*
^Consult Cement Backer Board manufacturer for specific
installation recommendations and to verify acceptability for exterior
use
*Interior use only and Laticrete primer to be applied to particle
board.
Packaging
- 7.6 & 19 litre pail  Color: Seafoam Green
Coverage
Approximately 15 –18 m2 per 19 litre pail and 6 –
7.2m2 per 7.6 litre pail
- Note: Watertight liquid is applied in 2 coats for a
total wet thickness of 1.0 - 1.5mm. Coverage
varies based on substrate texture & porosity, and
application technique.
Shelf Life Factory sealed containers of this product
are guaranteed to be of first quality for two (2) years
if stored indoors at > 0oC and < 43oC.
Limitations
- Not a wearing surface –cover with tile, stone or brick.
- Not for use in applications such as swimming pools,
fountains and the like, use LATICRETE 9235 (consult
LATICRETE).
- Do not expose to direct ultraviolet (UV) light for longer
- Do not apply too thick; dry thickness should not
exceed 2mm.
- Not designed for direct use over expansion joints,
control joints or structural cracks.
- Do not install when temperatures are below 7oC.
- Allow membrane extra curing time in cold or damp
weather.
- Not a vapour barrier.
- Do not use in areas subject to negative hydrostatic
pressure