Armeg Porcelain Drill Bit - Diamond Core - 6mm
- 6mm diamond core drill bit + 6mm pro masonry drill bit.
- Armeg PTC diamond drill bits feature thin wall, continuous diamond crowns for fast, efficient cutting and extended life. Not to be confused with short life diamond grit alternatives.
- Capable of cutting hundreds of holes in all grades of porcelain tile.
- With natural depth stop.
- Armeg PTC drill bits need a constant flow of water at the tip through the entire drilling process. This is best achieved using an Armeg water feed kit & adaptor (see related products below).
- Can also be used in marble, granite, travertine, natural slate, quarry tiles, ceramic tiles, natural stone, limestone, etc.
Frequently Asked Questions...
What speed should the drill bits be used at?
The diamond crowns can be used at any speed up to a maximum of 1500 rpm. Also suitable for use with cordless electric drills.
How quickly should I be able to produce a hole through a porcelain tile?
A hole should be produced through a porcelain tile in seconds rather than minutes. Excessive drilling times are usually due to insufficient pressure being applied through the drilling process or incorrect speed setting on the power tool.
How much pressure should I apply whilst drilling?
Sufficient pressure should be applied to keep the drill bit progressing through the tile (signified by tile dust being visible in the cooling water).
Why are there two drill bits in my plastic tube?
The drill bit with the red wax cover over the tip is the tile drill bit, the other is a professional quality masonry bit for producing the fixing hole behind the tile. Do NOT use the tile bit for drilling masonry!
Where to buy:
http://www.buybrandtools.comOur registered address is:
BuyBrandTools.Com
4a Abbey Crescent
Sheffield
S7 2QX
UNITED KINGDOM
Telephone: (0114) 251 3535
Fax: (0114) 251 3422
Email: This e-mail address is being protected from spambots. You need JavaScript enabled to view it
