DRY-TREAT 40N
DRY-TREAT 40N is an impregnating, invisible and breathable sealer that protects porous tile, natural stone, paving and grout from damage caused by water and salts. Treated indoor and outdoor surfaces become easier to clean, maintain and keep looking good for longer. DRY-TREAT 40N provides lasting protection for engineering concrete, render, terracotta tile, cast stone, paving, limestone, brick and grout.
Typical applications: DRY-TREAT 40N is suitable for a wide variety of applications, including building facades, floors, walls, swimming pool surrounds, patios, garages, kitchens and public and private entertaining areas.
Benefits: DRY-TREAT 40N non film-forming; able to work without changing the appearance of the surface - keeps the original look; suitable for indoor and outdoor use; able to greatly reduce water uptake and minimise moss growth, freeze thaw spalling and efflorescence; an excellent chloride ion salt screen - ideal for marine and pool areas; highly water vapour permeable - able to breathe so there is no build-up of subsurface moisture, allowing it dry out; deeply penetrating - protecting against weathering and wearing; very alkali resistant - won't breakdown in contact with cement based materials; and able to seal hairline cracks up to 0.3 mm (0.012 in.) and does not flake or peel, and able to stop rising damp.
Warranty: A 15-YEAR PERFORMANCE WARRANTY is offered when DRY-TREAT 40N is applied by an accredited applicator following our written instructions.
Application rate: Total application rate is approximately one litre per one to four sq. metres (10 to 40 sq. feet per quart) depending on absorption.
How to use:
1. ALWAYS TEST PRODUCT ON A SMALL AREA FIRST and allow a 24 hour cure time to determine the ease of application and desired results.
2. Ensure surfaces to be treated are dry, clean and free of residues.
3. Product is to be applied without thinning.
4. Generously saturate the surface with product using a low-pressure hand spray, a clean brush, or similar. Surface should have a mirror-like "wet" look for 3-5 seconds. Avoid contact with surrounding areas. 5. After 10 minutes, repeat Step 4. Total application rate is approximately one litre per one to four sq. metres (10 to 40 sq. feet per quart) depending on absorption.
6. Allow 10 minutes for product to penetrate surface then polish surface with a clean white dry cloth to remove excess product.
7. Clean equipment with organic solvent.
8. Sealer will not prevent surface etching or wear and may lighten or darken some surfaces.
Precautions: Do not take internally. Apply when surface temperature is between 5 - 35 ºC (40 - 95 ºF). Avoid moisture contact with the surface for six hours after application. Protect surrounding areas from over-spray. Keep away from drains, plants, water and soil. Use only in well-ventilated areas. Use a positive pressure respirator if ventilation is inadequate. Wear suitable solvent-resistant gloves, protective clothing, safety goggles and an organic vapour respirator during application. Avoid applying in windy conditions. Wash hands thoroughly.
Active content: A mixture of 40 per cent active content in alcohol.
Pack size: 20 litre pails.
Dry-Treat Dealer. Accredited Applicator.189 Marua Rd Ellerslie
Auckland Auckland New Zealand
Contact : Dino Gagas Phone 09 526 4581 , Fax 09 526 5909 , Mobile 021-930 066
Aucland
Website : http://www.lustre.co.nz
http://www.drytreat.com
Email : \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it
