Pilkington's Fine Joint Grout for wall and floor tiles with joint widths up to 12mm-Data Sheet.

Fine Joint Grout has been specially developed for wall and floor tiles with joint widths up to 12mm, ideal externally and internally in both wet and dry conditions, including swimming pools and power showers. Fine Joint Grout is highly suited to most common tile applications, including natural stone, porcelain, conglomerate and ceramic wall and floor tiles

Features

    * For use with1-12mm joint widths
    * Suitable for internal & external applications
    * Suitable in kitchens, bathrooms, swimming pools & power showers
    * Water repellent
    * Anti-fungal
    * Mould resistant

Properties
Constitution    Powder
Appearance    Powder in colours listed below
Mix Ratio    Fine Joint Grout should be added slowly to clean water in a suitable container in the approximate proportion of 3.5 parts powder to 1 part water. Mix until a smooth consistency is achieved
Application Temperature    5°C to 25°C
Open Time    Do not mix more than can be used in a 45-60 minute period, do not rewet or add too much water
Pot Life

60 minutes

6 months, when stored in cool, dry conditions and protected from excessive drafts
Set Time    24 hours
Coverage    Approx 0.3 kg/m2 (150x150x6mm tiles, 3 mm joints)
Colours    White, Limestone, Anthracite, Grey
Pack Sizes    White: 3.5kg / 12kg; Other colours 3kg
Notes    Times quoted are quoted at 20°C and are temperature/humidity dependent. Please note that certain tiles may suffer discolouration or scratching when using grouts, and it is recommended a test application be carried out prior to application
Preparation    Ensure that the adhesive is completely set and that tiles are firmly fixed. Ensure that joints are free from excess adhesive, dust, grease or any other contaminates
Application    Fine Joint Grout should be applied to the surface using a rubber backed trowel or squeegee. Work the mixed material thoroughly into the joints, a small area at a time. Ensure that joints are completely filled without voids before continuing. Excess grout should be removed as grouting proceeds
Grouting    After at least 3 hours. Temperature and conditions may affect the tile set, so check the tiles before grouting
Cleaning    Use a soft dry cloth to remove surface excess when grout has begun to dry (10-15 minutes)
MSDS    Click here to download a Material Safety Data Sheet for WHITE
Click here to download a Material Safety Data Sheet for GREY
Click here to download a Material Safety Data Sheet for LIMESTONE
Click here to download a Material Safety Data Sheet for ANTHRACITE

Contact Us.

http://www.pilkingtons.com

Pilkington's Group Customer Services

Tel: +44 (0)161 727 1111
Fax: +44 (0)161 727 1122
eMail : \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it

Technical Advice

Tel: +44 (0)161 727 1159
Fax: +44 (0)161 727 1122
eMail : \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it

Quiligotti Access, Acoustic and Hardwood Flooring

Tel: +44 (0)161 727 1070
Fax: +44 (0)161 727 1080
eMail : \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it

Supplier and Export Enquiries

Tel: +44 (0)161 727 1111
Fax: +44 (0)161 727 1122
eMail : \n This e-mail address is being protected from spambots. You need JavaScript enabled to view it